top of page

RotaChock® Mounting Plate

The installation of resilient mounts can be challenging. The rubber mount's base plate must be aligned perfectly parallel to the machine foot to ensure optimal vibration damping.

The traditional way to set up the resilient mount is to use the four adjustment bolts to eliminate any angle between the cap and the base plate and then to fill the gap between the base plate of the mount and the foundation with two-component epoxy resin or a tailor-made steel-fitted block.

mountingplate.480x0.png
  1. Spherical top ring for angular difference up to 2° between the machine foot and the foundation.

  2. Tool groove and holes to aid installation with a wide range of tools.

  3. Buttress thread design for maximum strength and stiffness.

  4. Standard ACE finish: Anti-Corrosion Enhanced for cost-effective corrosion protection.

  5. The footprint is large and reduces surface pressure.

  6. Type Approved by all major classification societies. 

The RotaChock® Mounting Plate offers an economical alternative to epoxy resin or tailor-made steel-fitted blocks. The adjustment bolts in the RotaChock® Mounting Plate are used to eliminate any angle between the mount's foundation and base plate. Now the four RotaChock® at the corners are adjusted to fill the gap. The base plate, RotaChock® Mounting Plate, and machine foundation are then tightened together securely with four foundation bolts.

The mounting system can be readjusted at any time if required. Just loosen the foundation bolts and adjust the RotaChock® Mounting Plate to meet your target alignment. The time needed to finish a typical resiliently mounted machine can be cut back from several days to only a few hours.

CALL US

TEL: +27 (0)83 262 9846

OFFICE +27 (0) 31 764 7425

EMAIL US
OPENING HOURS

Mon - Fri: 7am - 5pm

24 H +27 (0)83 262 9846

bottom of page